1/2 Return to MSR&LHA Home page

April 16-17, 2011 Work Session

The April 16-17 work session was a great one: The gear shaft for the #3 truck was assembled after some parts and tooling was constructed; flanging the bottom end of the first sand box commenced, again after making some tooling; The holes for the oil lines to the three new center plates were finish drilled, and the oil lines cut, threaded, and installed; And last but not the least, machining on the #2 truck gear shaft began.

Note: there are two pages of thumbnails for this album.

A-1 Water in the shop	B-1	B-2	B-3
B-4	L-1	L-2	L-3
L-3.1	L-3.2 -- huck wire for shart movement	L-4	L-5
L-6	S-2	S-3	S-4
S-5	S-5.1	S-6	S-7
S-7.1	S-8	S-9	S-1
S-2a	S-3a	S-4a	S-5a
T-2	T-3	T-4	T-5
T-6	T-7	ZZ101	ZZ2-1
ZZ2-12	ZZ202 - cradle modified for center of mass differential in gear with horns	ZZ203	ZZ204

jAlbum 9